150
ENGINES
AUXILIARY EQUIPMENT DRIVE BELT
Engine: RFN
Without air conditioning
Removing.
Raise and support the vehicle, wheels hanging.
Remove the front RH wheel, the plastic pins and the splash-shield.
Detension the belt (3) by turning the tensioner roller (1) by means of the screw
(2) (clockwise).
NOTE: Screw (2) has a left hand thread.
Compress the tensioner roller (1).
Remove the auxiliaries drive belt (3).
IMPERATIVE: Check that the rollers (4) and (5) turn freely (without play
and without tight spots).
Refitting.
Compress the tensioner roller (1).
Fit the auxiliaries drive belt (3).
IMPERATIVE: Make sure that the auxiliaries drive belt is correctly positioned
in the grooves of the various pulleys.
Complete the refitting.
Tightening torques:
Tensioner roller screw (4) : 2 ± 0,2 m.daN.
Guide roller screw (5) : 3,5 ± 0,,3 m.daN.
Wheel bolts :9 ±1 m.daN.
B1BP23PC B1BP23QC B1BP23RC
With air conditioning
To Next Page
Loading...
