211
ENGINES
ADJUSTING THE CAMSHAFT POSITION SENSOR
Engine: RHR
Tools.
[1] Setting peg for double flywheel : (-).0188.X
Adjusting the camshaft position sensor.
Peg the flywheel, using tool [1].
Sensor re-used.
Position a drill bit Ø 8,5 mm, at «e» (between the inlet valve cover (2) and the camshaft position
sensor (5)).
Tighten the screw (4) to 2 ± 0,2 m.daN.
Remove tools [2] and [3].
New sensor.
Place the camshaft position sensor (5) in contact with the target (camshaft pinion).
Tighten the screw (4) to 2 ± 0,2 m.daN.
B1EP1GGC
To Next Page
Loading...
