255
INJECTION
SPECIAL FEATURES: ADDITIVE SYSTEM
Open the tap located on the filler connector at «a».
Tilt the additive container (3) (to facilitate the end of filling).
Close the tap at «a».
Remove:
- The filler connector .
- The tube (4).
Couple the tube (2).
Reconnect the battery negative terminal.
IMPÉRATIVE: Reset the additive counters to zero, using a diagnostic tool.
Cleanliness requirements.
IMPERATIVE: The filling kit should be recycled after this operation. Any «Eolys» additive
containers that have been opened should not be kept.
C4BP1EGC
Filling the additive reservoir (continued)
To Next Page
Loading...
