Clarke Focus - Maintenance; Aligning the Front Wheel

Page -58- Clarke
®
Operator's Manual -Focus Rider Scrubber
3. Using the joystick, position the front wheel
straight by doing one of the following:
a) Using black indicator marks on steering
system, realign front wheel (see figure 37).
b) Place front wheel straight by visually
estimating it’s position (see figure 38).
4. Hold joystick in corrected position and
connect black wires together and key off the
machine (see figure 39).
5. Disconnect black wires.
6. Key machine on. If machine drives straight,
then proceed to step 7. If not, then repeat
steps 2-5.
7. Replace foot plate and screws.
8. Key machine on.
Maintenance
EN
Figure 37
Figure 38
Figure 39