10
Figure 2-5
6\VWHP6HWWLQJ$ODUP
Before the operation, please make sure you have properly connected the alarm devices. You can
refer to the User’s Manual for reference.
Alarm interface is shown as below. See Figure 2-6.
z Alarm in: Here is for you to select channel number.
z Event type: There are four types. Local input/network input/IPC external/IPC offline alarm.
¾ Local input alarm: The alarm signal system detects from the alarm input port.
¾ Network input alarm: It is the alarm signal from the network.
¾ IPC external alarm: It is the on-off alarm signal from the front-end device and can activate the
local NVR.
¾ IPC offline alarm: Once you select this item, system can generate an alarm when the front-end
IPC disconnects with the local NVR. The alarm can activate record, PTZ, snap and etc. The alarm
can last until the IPC and the NVR connection resumes.
z Type: Normal open or normal close.
z Enable: Please you need to highlight this button to enable current function.
z Period: Click set button, you can set alarm period. System can only generate an alarm in the specified
period. There are six periods in one day.
Please highlight icon
to select the corresponding function. After setting all the setups please click
save button, system goes back to the previous menu.
To Next Page
Loading...