13
Figure 2-9
If you are connecting to network PTZ, the PTZ type shall be remote. See Figure 2-10.
Figure 2-10
After completing all the setups please click save button, system goes back to the previous menu.
2.5.2 PTZ Operation
In one window display mode, right click mouse (click “Fn” Button in the front panel or click “Fn” key in the
remote control).
Click Pan/Tilt/Zoom, the interface is shown as below. See Figure 2-11.
Here you can set the following items:
z Step: value ranges from 1 to 8.
z Zoom
z Focus
z Iris
To Next Page
Loading...