56
Step 1
Prepare car seat for Forward-Facing
Installation:
• If Rear-Facing Base or Anti-Rebound
Bar is attached, remove it now, see
“Installing/Removing Rear-Facing Base”
on page 82 and “Installing/Removing
Anti-Rebound Bar” on page 85.
Step 2
Select a Forward-Facing vehicle seating
location which has LATCH.
Locate the LATCH lower anchors and top
tether anchor (as explained in the “Vehicle
Child Restraint Anchorage System (LATCH)”
on page 18 in this manual and in your
vehicle owner’s manual). See Figure 72.
Step 3
If the vehicle seat back is adjustable, make
sure the seat back is locked in a more upright
position. Refer to vehicle owner’s manual for
recommended seat back angle. DO NOT
install or use this car seat while the vehicle
seat back is excessively reclined, as shown in
Figure 73.
Figure 72
Figure 73
To Next Page
Loading...
