RADIUS SL 860 07.2019 en 16
The indicated hose diameters (NW) should be respected. The manufacturer is not responsible for
improper connections and such that are not correctly made. Furthermore, he is not responsible for break
downs on the tractor due to leakage and oil overheating. The oil quantities indicated in section 3.7.2 must
strictly be adhered to. The return flow hose bears only a pressure of 2 bar (29 psi). The operator must
make sure that the tractor’s hydraulic system is sufficient respectively that there is a recooling of the
hydraulic oil.
6 Commissioning
After the initial installation has been successfully completed, you should familiarize yourself with the operation of
the machine before starting work.
Attention:
Ensure that there are no persons within 10 meters (11 yards) of the machine/attachment.
The tractor operator is responsible for this!
After a prolonged standstill or after cleaning work, the entire machine must be checked for
damage or leaks.
In case of damage, the machine must be shut down immediately!
6.1 Road and transport travel
Please observe the safety instructions in these operating instructions.
For road travel, the machine/attachment is set so that its space consumption is minimal. Further settings must be
made in such a way that road traffic is not obstructed. The traffic regulations must be observed.
When driving on the road, the machine/attachment must be switched off.
In order to avoid traffic obstructions, all attachments and working implements as well as the tractor should be
freed from larger impurities which could come loose during road travel.
6.2 Operating and adjusting the machine
Attention:
When leaving the tractor for mounting, dismounting and making adjustments always switch
off the drive and engine.
Remove ignition key!
Secure the tractor and machine against unintentional movements (e.g. rolling away, lowering,
etc.).
Observe the relevant accident prevention regulations and all other information given in the
operating instructions!
When attaching or removing implements to the tractor do not step between tractor and
implement!
To Next Page
Loading...
Need help?
General
