Clevo P775TM1

Modules
Setting Up SATA RAID, Optane™ or AHCI Mode 6 - 27
6
Clearing Intel® Optane™
If you wish to clear an existing Intel® Optane™ setup then follow the procedure be-
low to do so. However
backup up any necessary files and data before clearing an
Intel® Optane™ setup
, as doing so will result in the loss of all data on the volumes.
1. Make sure that Intel® Optane™ is Enabled in the Intel® Rapid Storage Tech-
nology application.
2. Start-up your computer and press <F2> to enter the BIOS.
3. Go to Intel(R) Rapid Storage Technology (in the Advanced menu) and press
<Enter>.
4. Select Intel Optane, **** (listed under Optane Volume:) and press <Enter>.
Optane SSD Module
Removal
If you need to remove an
installed Optane SSD
module for any reason,
you must disable (see
“Disabling Intel® Op-
tane™” on page 6 - 73)
Intel Optane before
doing so.
Failure to disable Op-
tane before removing an
Optane SSD module will
result in the system be-
ing unable to start up.
Go to the BIOS to clear
the Intel Optane data.
Figure 6 - 15
Intel(R) Rapid
Storage Technology
(Advanced Menu)