CLIVET ELFOControl2 - SYSTEM SETTINGS; Configuration Options

80 pages

Save Page as PDF

To Next Page

To Previous Page

Page 26

SYSTEM SETTINGS

Access to the “System settings” is reserved only to the After sales

Centre

It allows setting:

2 - Parameters

3 - System layout

4 - Elfocontrol

select

Main Page

Table of Contents3
Main Functions5
Display6
Switching on and off the System6
Heating / Cooling / Automatic Mode6
- System7
- Start-Up and Switch-Off7
- Change Mode8
Adjusting Date and Hour9
- Set Heat Pump Operation10
- Climate Settings11
- Change of Set Point, from Fixed to Compensated12
- Modification of 4 Points12
- Modification of Supply Set Point12
- Modify the Outdoor Temperature13
- Domestic Hot Water Operation14
- Domestic Hot Water Settings14
- Domestic Hot Water Programming14
- Elfofresh16
- Fresh Air16
- "Away from Home" Control18
- Zone Scheduling19
- Zone in Manual Mode21
Alarms23
Modification of the Program Name24
System Setting26
Instructions for the Installer27
Elfocontrol28
- Led Function29
- Module RS48529
- Installation of the Serial Line30
- Shielded Cable30
Bus RS48530
System Diagrams31
- Unit for Producing Thermal and Cooling Energy33
- Fresh Air Unit37
Ambient Terminals38
- System Accessories41
- Radiant Panels - Ambient Terminals41
Thermostats41
Modules41
- Module of Radiant Areas with HID-T2, HID-TI2 and HID-T3 Thermostats42
- Module of Radiant Areas with Uncased Modbus Thermostats43
- The Radiant Zone Module Controls the Heated Towel Rail Valve44
- Radiant Zone Module Configuration45
System Component Configuration45
- Gaia Aria and ACQUA Version Ac/Gaia Maxi/Ground Medium47
- Addressing47
- System Component Addressing48
- Horus48
- Wsan-Xin49
- Elfoenergy/Elfofresh50
- Terminal, Area Modules with HID-T2, HID-T3 Thermostats Addressing51
- Terminal, Area Modules with HID-TI2 Thermostats Addressing52
- HID-TI4 and HID-UR Thermostats Addressing53
- Radiant Zone Module Addressing54
- Mixing Module Addressing55
- RS485 Module Addressing55
- BT2 External Temperature Reading Probe Addressing55
- Zone Module (Heated Towel) Addressing56
- I/O Module Addressing57
- Domestic Hot Water Module Addressing60
- System Configuration61
- Installation Composition66
Autoconfiguration67
- System Component Status69
- Verification of the Component Communication69
- Zone Element Status70
- Status of the Mixers70
- Error: RS485 Network73
- Troubleshooting73
Disposal73
Parameters of the Components74
- Modbus TCP / IP75
- Plant Commands75
- Areas Commands76
- Domestic Hot Water Commands76
- Elfofresh Commands76
- Plant Stata76
- Area Stata77
- Elfofresh (EF) Stata77

CLIVET ELFOControl2 - SYSTEM SETTINGS; Configuration Options

Table of Contents

Related product manuals