CLIVET ELFOControl2 - AUTOCONFIGURATION; Troubleshooting Auto-configuration

80 pages

Save Page as PDF

To Next Page

To Previous Page

Page 68

AUTOCONFIGURATION

If you do not see “ Autoconfiguration completed”:

1. check the element is in ON

2. check the network

Main Page

Table of Contents3
Main Functions5
Display6
Switching on and off the System6
Heating / Cooling / Automatic Mode6
- System7
- Start-Up and Switch-Off7
- Change Mode8
Adjusting Date and Hour9
- Set Heat Pump Operation10
- Climate Settings11
- Change of Set Point, from Fixed to Compensated12
- Modification of 4 Points12
- Modification of Supply Set Point12
- Modify the Outdoor Temperature13
- Domestic Hot Water Operation14
- Domestic Hot Water Settings14
- Domestic Hot Water Programming14
- Elfofresh16
- Fresh Air16
- "Away from Home" Control18
- Zone Scheduling19
- Zone in Manual Mode21
Alarms23
Modification of the Program Name24
System Setting26
Instructions for the Installer27
Elfocontrol28
- Led Function29
- Module RS48529
- Installation of the Serial Line30
- Shielded Cable30
Bus RS48530
System Diagrams31
- Unit for Producing Thermal and Cooling Energy33
- Fresh Air Unit37
Ambient Terminals38
- System Accessories41
- Radiant Panels - Ambient Terminals41
Thermostats41
Modules41
- Module of Radiant Areas with HID-T2, HID-TI2 and HID-T3 Thermostats42
- Module of Radiant Areas with Uncased Modbus Thermostats43
- The Radiant Zone Module Controls the Heated Towel Rail Valve44
- Radiant Zone Module Configuration45
System Component Configuration45
- Gaia Aria and ACQUA Version Ac/Gaia Maxi/Ground Medium47
- Addressing47
- System Component Addressing48
- Horus48
- Wsan-Xin49
- Elfoenergy/Elfofresh50
- Terminal, Area Modules with HID-T2, HID-T3 Thermostats Addressing51
- Terminal, Area Modules with HID-TI2 Thermostats Addressing52
- HID-TI4 and HID-UR Thermostats Addressing53
- Radiant Zone Module Addressing54
- Mixing Module Addressing55
- RS485 Module Addressing55
- BT2 External Temperature Reading Probe Addressing55
- Zone Module (Heated Towel) Addressing56
- I/O Module Addressing57
- Domestic Hot Water Module Addressing60
- System Configuration61
- Installation Composition66
Autoconfiguration67
- System Component Status69
- Verification of the Component Communication69
- Zone Element Status70
- Status of the Mixers70
- Error: RS485 Network73
- Troubleshooting73
Disposal73
Parameters of the Components74
- Modbus TCP / IP75
- Plant Commands75
- Areas Commands76
- Domestic Hot Water Commands76
- Elfofresh Commands76
- Plant Stata76
- Area Stata77
- Elfofresh (EF) Stata77

CLIVET ELFOControl2 - AUTOCONFIGURATION; Troubleshooting Auto-configuration

Table of Contents

Related product manuals