EasyManuals Logo

CLIVET WiSAN-PME 1 S User Manual

CLIVET WiSAN-PME 1 S
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
21
Before installation
5. Before installation
5.1 Prerequisites
This section is intended exclusively for the Installer.
Refer to the Technical data chapter for details.
Follow the safety instructions in the "About R-290 refrige-
rant" a pag. 8.
When handling the unit, use equipment appropriate to
the weight of the unit.
Check that all handling equipment complies with local
safety regulations (cran, forklifts, ropes, hooks, etc.).
During manual operations, it is mandatory to comply with
the maximum weight per person as required by current
legislation.
Provide personnel with personal protective equipment
appropriate for the situation, such as hard hat, gloves,
safety shoes, etc.
Observe all safety procedures in order to guarantee the
safety of the personnel present and the of material.
To avoid injury, do not touch the units air inlet or alumi-
nium ns.
Do not use the fan grille handles to move the unit.
Keep the unit packed during handling.
Remove the packaging when you have reached the point
of installation.
5.2 Reception
Before accepting the delivery, check:
that the unit has not been damaged during transport
that the materials delivered match those indicated on the
transport document, comparing the data with the serial
number label on the packaging.
In case of damage or anomaly:
immediately write down the damage found on the tran-
sport document and quote this sentence: “Accepted with
reservation due to evident shortages/damages during
transport”
contest by fax and registered mail with proof of receipt to
the supplier and carrier.
Any disputes must be made within 8 days from the
date of the delivery. Complaints after this period are
invalid .
5.3 Storage
Respect the indications on the outside of the pack.
In particolar:
minimum environment temperature -25 °C (possible
damage to components)
maximum environment temperature +70 °C
maximum relative humidity 95% (possible damages to
electrical components).
5.4 Handling
The unit can be handled:
with a hoist or crane
with a forklift truck or pallet truck
The following examples are guidelines; the choice of means
and handling modes will depend on the actual installation
situation.
Position of the centre of gravity
C
A
B
A
Size A B C
2.1-3.1 mm 333 528 210
4.1-5.1 mm 360 550 234
6.1-8.1 mm 415 715 200

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CLIVET WiSAN-PME 1 S and is the answer not in the manual?

CLIVET WiSAN-PME 1 S Specifications

General IconGeneral
BrandCLIVET
ModelWiSAN-PME 1 S
CategoryHeat Pump
LanguageEnglish

Related product manuals