CLIVET WiSAN-YME 1 S 4.1 User Manual

120
Control
9.11 Select operation mode
Select the operation mode on the interface, go to
MENU > OPERATION MODE
Press OK.
Three modes are available:
HEAT for heating, COOL for cooling and AUTO for automatic
control.
Press LEFT or RIGHT to scroll, press OK to select.
When the cursor is moved to an operation mode and the page
is exited with the BACK button, that mode is activated even if
the OK button has not been pressed.
OPERATION MODE
Operation mode setting:
HEAT COOL AUTO
7
OFF
ON
OFF
ON
7
OFF
ON
OFF
ON
7
OFF
ON
OFF
ON
OK
CONFIRM
Mode Operation mode
7
OFF
ON
OFF
ON
Heating Mode
7
OFF
ON
OFF
ON
Cooling Mode
7
OFF
ON
OFF
ON
The software automatically changes the mode
according to the outdoor temperature, indoor
temperature and depending on the installation settings
(taking into account the monthly limitations).
NOTE
automatic change is only possible under certain
conditions. See FOR SERVICEMAN > AUTO MODE
SETTING.
To control the operation mode with the room thermostat, see
FOR SERVICEMAN > ROOM THERMOSTAT.
Select
MENU > OPERATION MODE
Press any selection or control button and the following page
will be displayed, if room thermostat = MODE SETTING is
selected
01-01-2021 9:00
7
OFF
ON
OFF
ON
The cooling/heating mode is
controlled by the thermostat.
Adjust the mode with the room thermostat.
OK
CONFIRM

CLIVET WiSAN-YME 1 S 4.1 Specifications

General

Brand	CLIVET
Model	WiSAN-YME 1 S 4.1
Category	Heat Pump
Language	English