CLIVET WiSAN-YME 1 S 4.1 User Manual

127
Control
9.15.3 Tank heating
The TANK HEAT. function is used to force the water to heat
up in the storage tank (using the storage tank heater) in cases
where the heat pump is on for heating or cooling functions but
there is still a demand for domestic hot water.
The TANK HEAT. function can be used to heat the water in the
storage tank even if the heat pump has failed.
Select
MENU > DOMESTIC HOT WATER > TANK HEAT.
Press OK
DOMESTIC HOT WATER (ACS)
DISIN-
FECT
FAST
DHW
HEAT.
TANK
PUMP
DHW
CURRENT STATE ON
ON/OFF ON/OFF
ON/OFF ON/OFF
DOMESTIC HOT WATER (ACS)
DISIN-
FECT
FAST
DHW
HEAT.
TANK
PUMP
DHW
CURRENT STATE OFF
ON/OFF ON/OFF
Press ON/OFF to select ON or OFF.
Use BACK to exit.
If the TANK HEAT. function is on, the following page appears
NOTE
If CURRENT STATE is OFF, the TANK HEAT. function is dis-
abled. If the storage tank sensor T5 is faulty, the heater will
not start.
01-01-2021 9:00
7
OFF
ON
OFF
ON

CLIVET WiSAN-YME 1 S 4.1 Specifications

General

Brand	CLIVET
Model	WiSAN-YME 1 S 4.1
Category	Heat Pump
Language	English