155
MODBUS registers
Address
register
Meaning Description
255 t_DRYUP
Heating days; Default 8 days; Control interval:
4 ~15 days
256 t_HIGHPEAK Floor drying days. Default 5 days, Control interval: 3 ~ 7 days
257 t_DRYD Cooling days. Default 5 days. Control interval: 4~ 15 days
258 T_DRYPEAK
Max floor drying temperature.
Default 45°C; Control range: 30-55°C.
259 t_firstFH
Time of first floor heating.
Default value 72 hours; control interval 48-96 hours
260 T1S(First warm)
Leaving water temperature for preheating radiant panels. Default: 25°C;
Control range 25~35°C
261 T1SetC1
Temperature curve parameters in cooling mode 9,
Range setting 5-25°C, default 10°C
262 T1SetC2
Temperature curve parameters in cooling mode 9,
Range setting 5-25°C, default 16°C
263 T4C1
Temperature curve parameters in cooling mode 9,
Range setting (-5)-46°C, default 35°C
264 T4C2
Temperature curve parameters in cooling mode 9,
Range setting (-5)-46°C, default 25°C
265 T1SetH1
Temperature curve parameters in heating mode 9,
Range setting 25-60°C, default 35°C
266 T1SetH1
Temperature curve parameters in heating mode,
Range setting 25-60°C, default 28°C
267 T4H1
Temperature curve parameters in heating mode,
Range setting (-25)-35°C, default -5°C
268 T4H2
Temperature curve parameters in heating mode,
Range setting (-25)-35°C, default -7°C
269
Current limitation scheme,
0= no setting;
1~8= Scheme 1~8,
predefined 0
270
HB: t_T4_FRESH_C Interval setting 0.5 - 6 hours, send value = current value * 2
LB: t_T4_FRESH_H Interval setting 0.5 - 6 hours, send value = current value * 2
271 T_PUMPI_DELAY Interval setting 2-20, send value = current value * 2
272
EMISSION TYPE
Bit12-15= Zone 2 Type of cooling terminal
Bit8-11= Zone 1 Type of cooling terminal
Bit4-7= Zone 2 Type of heating terminal
Bit0-3= Zone 1 Type of heating terminal
To Next Page
Loading...
Need help?
General