MAN.241 Rev.5 ENG - Use and maintenance manual S23 page 21 of 127
for a few seconds: this will cause the corre-
sponding orange light 2 (Picture 4) to turn on.
The ignition of the endothermic engine can also be
carried out with the radio/wired control. Using it on
the ground or in the basket:
• turn the SK key to position 1;
• move the lever in the Picture 5 upwards, pre-
sent on the left bottom side of the radio/wired
control (Picture 8);
• in this case, the green light 5 (Picture 4) will
light up on the switching on/off station to sig-
nal the correct power supply of the machine.
Picture 5: power on/off lever on
the radio/wired control.
To switch off the endothermic engine, you can alter-
natively:
• turn the SK key all the way to the left on posi-
tion 0;
• lift the lever in Picture 5, on the radio/wired
control;
• press, in emergency situations, one of the
emergency buttons on the machine (par.
4.5.1).
3.1.2 Ignition of the electric engine (*op-
tional)
If you choose to use the auxiliary electric engine
(*optional):
• connect the 110/120/230 V socket to the
nearest electrical source (Picture 6);
Picture 6: power line socket.
• from the radio/wired control, start the engine
by pushing the lever in Picture 5 downwards;
To Next Page
Loading...
Need help?
General
