MAN.241 Rev.5 ENG - Use and maintenance manual S23 page 23 of 127
Picture 7b: dual power sockets*.
Moreover, the machine can be supplied on request
with a 48 V electric engine powered by 160 Ah lithium
batteries.
The start and stop of the 48 V electric engine will be
the same shown above for 110/120/230 V electric en-
gine.
It is not possible to have the 48 V electric
engine and the 110/120/230 V one acti-
vated on the machine at the same time.
It is not possible to turn on both the endo-
thermic engine and the electric engine at
the same time.
To recharge the lithium batteries pack:
• couple the 110/120/230 V socket (power line) to
the plug on the machine and lift the button pro-
vided on the machine's thermal magnetic panel;
• from this moment the batteries will be charging
and, if the electric system is ON, the progress
of the charging process will be shown on the
control station led panel (Picture 9).
When the state of batteries charge, during
the use, reaches the lowest level (under
10%), all work maneuvers will be inter-
rupted, and it will only be possible to close
the machine again.
To Next Page
Loading...
Need help?
General
