MAN.241 Rev.5 ENG - Use and maintenance manual S23 page 42 of 127
The bypass, at this point, will be active and the oper-
ator will be able to take the machine back to the con-
ditions prior to the block (travel in the original direc-
tion), until stopping the previously activated acoustic
warning.
C.M.C. DECLINES ANY TYPE OF
RESPONSIBILITY TO THE OPERATOR. THE
MANUFACTURER HAS CLEARLY ESTABLISHED
TWO ACOUSTIC WARNING THRESHOLDS, IN
ORDER TO FULLY INFORM THE USER ABOUT
THE DANGERS DUE TO THE NON-
RECOMMENDED ACHIEVEMENT OF TRAVEL
SLOPE LIMIT.
4.4 MEWP operation proce-
dures
The machine is equipped with the "SCS System"
(Self Control System) which allows:
• automatic stabilization,
• automatic speed control,
• automatic closing of the aerial part.
The following procedures shall be care-
fully carried out in the correct chronologic
order.
If full lithium version (*optional), before
any work start, check the battery charge
level. It is necessary to have at least 75% of
battery charge, otherwise it is advisable to
charge them before working.
4.4.1 Placement on the work area
1. Start the endothermic/electrical engine us-
ing the supplied engine ignition key (Picture
4);
2. identify the work area, which is nearest to
the workplace;
3. make sure the soil bears the load of the out-
riggers and check that there are no man-
holes, floors or other soft structures in the
contact point of every stabilizer plate with
the ground;
To Next Page
Loading...
Need help?
General
