19
Getting Started with your Shortcuts
By default, you will have the following shortcuts pre-installed on your controller’s desktop:
To begin operating, click on the Python icon on your desktop. After loading, you will see the Main Screen.
This is where you upload all your files from your CAD/CAM software. When saving files here, we
recommend saving all files of a single job in 1 folder. We do not recommend saving a folder inside another
folder (or multiple file levels) as this may cause a program error.
The program contains all the controls for
all
functionalities of CNC Factory 5th generation
routers. Further upgrades may be required on your router to perform all these functionalities.
Please contact support@cncfactory.com if you wish to upgrade your router.
• Python icon
• CNC File folder [This PC > Local Disk (C:) > Network > CNC > NcFiles]
To Next Page
Loading...
Need help?
General
