COBHAM Explorer 510 - Page 112

Appendix B: Command reference
98-143082-D SMS remote commands 104
Parameters
The table below summarizes the available parameters for the SMS remote commands.
Parameter Values Meaning
<apn_type> SIM default
Network
assigned
User defined
NA
Read the APN from the SIM card.
Use the APN assigned by the network.
Specify another APN to use.
Placeholder when no value is specified. The existing setting applies.
<apn> <APN>
NA
CLR
APN name, e.g. bgan.inmarsat.com.
Placeholder when no APN is specified. Note that any previously entered APN
is maintained.
No APN is used.
<at_cmd> <at_cmd> AT command, without prefix AT. For supported AT commands, see ATCO
commands on page 109.
<category> 1
2
3
4
Delete only Read SMS messages.
Delete Read and Sent.
Delete All except Unread.
Delete All SMS messages.
<cmd_op> 1
2
Get WANMODE setting
Set WANMODE configuration
<dataset> GPS
USAGE
ALL
GPS position.
Cumulative call time and data usage.
GPS position plus call time and data usage.
<get_set> 1
2
Get parameters.
Set parameters.
<imei> <14 digits> IMEI of the EXPLORER 510, without dashes or check digit.
<info_mode> 1
2
For GPS query: position data only. For other queries: use verbose mode (with
titles).
For GPS query: position data plus SMS usage. For other queries: use terse
mode (no titles).
<interval> <integer>
NA
The number of hours between the Terminal watchdog sessions (1-504).
Placeholder when no value is specified. The existing setting applies.