COBHAM Explorer 510 - Page 121

Appendix B: Command reference
98-143082-D AT commands 113
Other M2M related AT commands
Parameters for other M2M related AT commands
The table below summarizes the available parameters for the AT commands for M2M
operation.
Command Parameters
_ICLCK
<type> <enable> <passwd>
_IMACLOC
<enable> <interface> [<interface>]
_IMACLOCAD
<action> <interface> <MAC Address> [<MAC Address>]
a
a. Up to 10 MAC addresses may be specified.
_ISMSRMT
<enable>
_ITDCIV
No parameters
b
b. Type _ITDCIV? to get the input voltage (in mV) of the EXPLORER 510
Parameter Values Meaning
<action> 0
1
Delete.
Add.
<enable> 0
1
Disable.
Enable.
<interface> 0 0 means Ethernet interface. This is the only option.
<MAC Address> <MAC Address> MAC address(es) for MAC locking. Up to 10 MAC addresses are permitted.
<passwd> <passwd> The existing administrator password.