COBHAM Explorer 510 - Page 122

Appendix B: Command reference
98-143082-D AT commands 114
Context management AT commands
The table below summarizes some of the most used AT commands for context management.
Parameters are explained in the table in the next section.
Parameters for context management AT commands
The table below summarizes the available parameters for the AT commands for context
management.
Note
The context management AT commands can only be used over a BGAN connection
and will not work on a cellular connection.
Command Parameters
+CGACT <state> <cid>
+CGDCONT <cid> <protocol> <apn> <apn uname> <apn_passwd>
+CGDSCONT <cid> <p_cid>
+CGEQMIN <cid> <Traffic Class> <Max bitrate UL> <Max bitrate DL> <Guaranteed bitrate UL>
<Guaranteed bitrate DL>
+CGEQREQ <cid> <Traffic Class> <Max bitrate UL> <Max bitrate DL> <Guaranteed bitrate UL>
<Guaranteed bitrate DL>
+CGPADDR <cid>
+CGTFT <cid> <packet filter identifier> <evaluation precedence index> <source addr & subnet>
<protocol number> <destination port range> <source port range>
Parameter Values Meaning
<apn passwd> <apn passwd>
NA
Password for the APN.
Placeholder when no APN is specified.
<apn uname> <apn uname>
NA
User name for the APN.
Placeholder when no APN is specified.
<apn> <apn>
NA
APN name.
Placeholder when no APN is specified. The default APN from the SIM is used.
<cid> <cid> The Context Identifier (1 – 11) for the PDP context.
<destination port
range>
<destination
port range>
Destination port range in the form From.To
To indicate only one port number, type in the same port number under From
and To.
Example: 65333.65338 indicates port numbers from 65333 to
65338, both included.