Chapter 4: Configuration
98-143082-D Advanced settings 74
Prepare the terminal for remote access with SMS
1. From the Remote management page, locate the section Remote access with SMS.
2. Select whether you want to Enable remote SMS commands.
3. Enter the password for remote SMS. It can be 5 to 15 characters long. The characters 0-9,
a-z and A-Z are allowed. The password is mandatory. This password must be entered
every time you send an SMS command. Default password is remote.
See Remote access with SMS on page 23.
4. Select Trust all phone numbers or, at Trusted phone numbers, enter at least one
trusted mobile number from which the terminal accepts an SMS. Use the wild card * to
accept a range of trusted numbers. Leave out the prefix before the country code (example:
for “+45” write only “45”)
5. To add more phone numbers, click Add phone number again.
6. At Static IP addresses for SMS data activation, click Add IP address and add any
static IP addresses used by locally connected equipment for which a data connection
should be activated when the EXPLORER 510 receives an “ACTIVATE” or “DEACTIVATE”
SMS command.
7. Click Save.
For information on how to send SMS commands, see Remote access with SMS on page 23.
The terminal must be logged on to the BGAN satellite services to receive and accept
an SMS.
Entered mobile number with wild card Mobile numbers accepted
453955880* +4539558800 to +4539558809
45395588* +4539558800 to +4539558899
If you select Trust all phone numbers you should take security measures
such as changing the SMS remote password in order to avoid unintended
use.
To Next Page
Loading...
