Chapter 4: Configuration
98-143082-D Advanced settings 75
Remote control of tracking
When you are using the tracking function of the EXPLORER 510, you can set up the terminal so
that the tracking server can access the EXPLORER 510 e.g. to start or stop tracking or to change
reporting intervals.
To allow the tracking server to control the tracking settings, do as follows:
1. Under Advanced, select Tracking settings.
2. Select Allow remote control of tracking.
3. Click Save.
The EXPLORER terminal will now accept commands from the specified tracking server, for
example to change reporting intervals or start/stop reporting.
Help desk
Under Help desk you can enter the contact information you want for your EXPLORER 510. The
Help desk contact information is empty by default. You must provide the contact information,
e.g. the phone number for your Airtime Provider. Do as follows:
1. In the Advanced page, select Help desk.
2. Type in the contact information you want.
3. select Save.
The Help desk information is now available from the About page (
(Control panel) >
Support > About).
Reset button
You can change the function of the Reset button. Do as follows:
1. From the Advanced page, select Reset button.
2. Select the behavior you want for the Reset button.
• Enabled: Short push: Reset WLAN settings, Long push: Reset to factory default.
• Long press disabled: A push on the Reset button will only reset the WLAN settings,
regardless of how long you push the button.
• Disabled: The Reset button will not have any function, except when you push and hold
it while the terminal is starting up (Safe mode, see Restore the settings of the
EXPLORER 510 on page 82).
3. Click Save.
To Next Page
Loading...
