7
Chapter 2
22222
Operation
Operation 2
This chapter has the following sections:
• To get started
• Position
• Anchor Watch
• Trip Counters
• Settings
• Alert and notification management
• List of alerts
• Multiple receivers
To get started
As soon as DC power is provided the GNSS/DGNSS Receiver is on.
To switch on the Control Panel push the power button.
Operate the Control Panel by tapping the touch screen. To
switch off the Control Panel push and hold the power button
for 2 seconds and follow the instructions on the screen.
To dim the display of the Control Panel
Turn the dim knob of the Control Panel to increase or decrease
the display brightness or tap Auto. To dim to level zero push
the power button once. If an alert appears while the display is in
level zero, the display returns to the latest dim value and the
alert is displayed.
Note
If the remote switch in the Control Panel is wired and it is
switched on, you can only use the Power button to reboot the
Control Panel, you cannot switch it off.
To Next Page
Loading...
