Startup sequence
98-175666-D Chapter 3: Setup of the antenna 3-46
Example: EVENT 1/4*: This is the first event out of a list of 4 and there has been a
change in the list. EVENT 1/4 will always be shown, the * indicates that
there has been a change.
3.5 Startup sequence
Once the system is configured and a VSAT profile is active, the startup sequence is as
follows:
• Antenna POST pending
• Antenna SW upload (If the software versions in the ADU and are not the same, a
software update is done during startup.)
• Antenna POST
• Ready
• Acquiring Signal
• Tracking
When the display shows TRACKING and the LED Logon is steady green, the system is
operational.
EVENT Description
<EVENT> In this menu all active events are listed. Use and to go through the
active events.
If a new event occurs or there is a change in the event list while you are in
the EVENTS menu, a * is shown in the upper left corner of the display,
next to the menu name. Press OK to update the EVENTS list, the * will be
removed.
A > means the event text is longer than the display can show. Press to > to
see the remaining text.
Table 3-24: EVENTS menu of the BDU
To Next Page
Loading...
Need help?
General
