COBHAM Satcom SAILOR XTR GX-R2 User Manual

Integration of a 3rd party IP device
98-175666-D Chapter 2: Installation 2-41
2.9 Integration of a 3rd party IP device
This section describes how to integrate a 3rd party IP device inside the antenna
radome of the SAILOR 1000 XTR GX-R2. The antenna has the following interfaces for
the integration:
• Power connector
• Communication
• Mechanical interface
2.9.1 Power connector
The power output options are 12 VDC / 2A and 5 VDC / 2A. The physical interface is a
Molex 105308 4-pin nano-fit connector on the XTR Antenna Control Module (ACM).
2.9.2 Communication
The ACM has four Ethernet LAN ports. LAN port 1 and 2 can be tunneled to the LAN
ports of the BDU. The BDU LAN port and ACM LAN port are a transparent data channel
that connects two devices.The ACM LAN ports are set up in the web interface.
Figure 2-37: ADU power on off (left) and ACM 4-pin nano-fit connector
Figure 2-38: ACM LAN ports

COBHAM Satcom SAILOR XTR GX-R2 Specifications

General

Brand	COBHAM
Model	Satcom SAILOR XTR GX-R2
Category	Marine Equipment
Language	English