Settings
98-175666-D Chapter 3: Setup of the antenna 3-10
3.2.3 Network settings
On this page you enter the host name and set up the network settings for the LAN ports
of the BDU and the LAN ports of the ADU.
Static IP or DHCP Client
The default setting for LAN Port 3 is DHCP client.
If you select DHCP client the network IP address and sub-net mask must be provided
by a DHCP server on that network. If you select Static IP address you must specify a
unique IP address and a sub-net mask.
DHCP Server Settings.
On the service LAN port 5 at the front you can select to run a DHCP server. Select the
check box DHCP Server. The DHCP start and end addresses must be on the same
network as the port's static IP. The default setting for service LAN port 5 at the front is
DHCP server.
DNS setup
If you have access to a Domain Name Server (DNS) you can specify the address of the e-
mail server by using the server name instead of its IP address. This can be used in
Outgoing mail server in E-mail setup (secure e-mail) on page 3-22. You may statically
specify the address of one or two DNS. Select the DNS source as static and fill in IP
address or addresses. Alternatively, if your DHCP server can provide a DNS address and
you have selected DHCP client above, then select the same LAN as your DNS source.
Figure 3-10: Settings, Network page (example)
To Next Page
Loading...
Need help?
General
