CB-MF-SOP-002
A/1
36
Figure 13-3
9. Finally unscrew the self-tapping screws at the edge of the bottom of the packing box.
Because of the heavy equipment, it is recommended to use special equipment such as forklift.
Storage and transportation shall meet the requirements of EN ISO 780-2015 Packaging —
Distribution packaging — Graphical symbols for handling and storage of packages, and shall
also meet the requirements of storage and transportation environment in the technical
parameters of this specification.
Attention:
⚫ Again carrying and packing the process should pay attention to handle gently, because the
host as the heavy equipment, at least two people carrying, to pay attention to the safety of
personnel and equipment.
14 Product Feature
1. Product feature: It is continuous running bench laboratory equipment, connected with the
power grid through the dismountable power cord.
2. Safety Class: Class II
3. Rated pollution grade: level 2
4. Operating environment: indoor use shall meet the operating environment requirements of
item 10 in this manual.
15 Caution, Warning and Note
1. Check whether the parts are intact or not according to the packing list before
installation. If the package is incomplete or damaged, please contact your dealer
immediately.
2. Do not put the instrument in direct sunlight, because strong sunlight will interfere
with the instrument's optical sensor.
3. It is very important to remove the plastic tape and fixation screw of the sampling
module before starting up. When the power is turned on, the instrument is initialized,
including the motion check of each component. If the strap and fixing screw are not
removed, the instrument may be damaged.
To Next Page
Loading...