Definitions
Manpack Transceiver 2110 series Getting Started Guide 79
Emergency call A call that enables you to trigger an
emergency alarm at a specific station then
speak to an operator there.
frequency The number of cycles per second of a radio
wave, usually expressed in kilohertz.
front panel The interface that is used to control the
functions of the 2110 series Manpack
Transceiver. It consists of a display, keypad
and connectors for the handset, antenna,
ancillary equipment, and earthing.
Get Position call A call that gets the GPS position of a
specific station.
Get Status call A call that gets diagnostic or configuration
information about the transceiver at a
specific station.
hot key A key on the front panel that is pre-
programmed with a macro that enables you
to perform a task quickly.
Last Heard Log A log of the last 100 on-air transmissions
detected by the current station.
The Last Heard Log is available if the MIL-
STD-188-141B ALE option is installed
(2110 only).
link A link is established following a 3-way
handshake process. Scanning is off and a
timeout, set using the Cfg In Call Timeout
entry in the Control List, is active.
With ALL calls and NET calls that are set to
link immediately, the linking establishment
process is 1-way.
This term Means...
To Next Page
Loading...
Need help?
General
