Installation
46 Block Up Converter Systems 6700/6900 series User Guide
1 If you want to allow for dry air pressurisation, fit the
supplied air nozzle to the blanking plate. If this is not
required, fit the M5 screw with seal into the blanking
plate.
1 Connect the off-line BUC termination to port 4 of the
coaxial section of the switch as shown in the mounting
and interconnection drawings.
1 Connect the outputs of the BUCs to the corresponding
N-type connectors of the coaxial section of the switch
using the coaxial cables supplied.
1 Connect port 2 of the coaxial section of the switch to the
transmit port of the antenna feed using the coaxial cable
supplied.
1 Seal all N-type connections with self-amalgamating tape.
1 Connect the combined RF waveguide/coaxial switch to
the LNB Switch Control connector using the cable
supplied.
NOTE
In some configurations, the termination
consists of multiple parts.
CAUTION
Ensure all joints are completely
weatherproof.
NOTE
Spare flange kits are supplied with the
redundancy package to provide for various
installation requirements.
NOTE
The BUC Switch Control connector is
not used in this configuration.
To Next Page
Loading...
Need help?
General
