Compliance
Block Up Converter Systems 6700/6900 series User Guide 123
Electromagnetic compatibility and safety
notices
Radiation safety
Electromagnetic compatibility
To ensure compliance with the EMC Directive is maintained,
you must:
1 Use standard shielded cables supplied from Codan
(where applicable).
1 Ensure the covers for the equipment are fitted correctly.
WARNING
A radiation hazard exists if the BUC is operated
with its RF output unterminated. Do not operate
the BUC without a load or termination attached
to the RF output.
CAUTION
If it is necessary to remove the covers at any
stage, they must be refitted correctly before
using the equipment.
CAUTION
The dust caps supplied with the Redundancy
Controller 6586 must always be fitted to the
relevant connectors when the connections are
not in use. This enables any electrostatic charge
on service personnel or equipment to discharge
safely via the dust cap prior to connecting a
cable to the port.
To Next Page
Loading...
Need help?
General
