Codan Envoy 2220 - Entering a self address

USING THE WIZARD
USING THE WIZARD
ENVOY™ TRANSCEIVER GETTING STARTED GUIDE 19
1 Press (Options), scroll to Save, then press
(Select).
1 Press (Save) to save the information.
Entering a self address
To enter a self address:
1 Enter the address that you want to use.
You can enter up to six digits.
NOTE: Addresses ending in 99 and 00 have a
special function in Selcall HF networks.
1 Press (Save) to save the information.
NOTE: The wizard automatically allocates this
self address to the default HF networks:
Selcall and CALM (if FED-STD-1045
ALE or MIL-STD-188-141B ALE option
is installed).
1 Do one of the following:
• If you want to add a contact, press (Yes), then
continue from Adding a contact on page 20.
• If you do not want to add a contact, press (No),
then continue from Selecting an antenna on page 23.