USING THE WIZARD
USING THE WIZARD
24 ENVOY™ TRANSCEIVER GETTING STARTED GUIDE
1 Do one of the following:
• If you want to connect accessories to the 15-way port
of the RF unit, press (Yes), then continue from
Selecting a peripheral device on page 24.
• If you do not want to connect an accessory,
press (No), then press OK to close the wizard.
Selecting a peripheral device
To select a peripheral device:
1 Press or to scroll to the type of peripheral device that
is attached to the connector, then press OK.
If there are settings that you can change to optimise this
peripheral for your requirements, is shown to the right of
the peripheral name when it is selected.
1 If you want to change settings for the peripheral, press to
see the list of entries that you may change.
1 Press (Save) to automatically update settings for
correct operation of the connected peripheral device.
1 Press OK to close the wizard.
1 If you added a peripheral device, restart your transceiver to
activate the new settings.
To Next Page
Loading...
Need help?
General
