USING THE WIZARD
USING THE WIZARD
ENVOY™ TRANSCEIVER GETTING STARTED GUIDE 21
Adding a Message call
To continue with adding a Message call:
1 Press to move to the Selcall | ALE Address entry.
1 Enter the address of the station that you want to call.
1 Press to move to the Message entry, then press .
1 If you want to enter a message:
• Start typing the message.
NOTE: Press OK to start a new line, if
required.
•Press (Options), scroll to Save, then
press (Select) to add the message to the call.
1 If you want to select a message from a list of stored
messages:
•Press (Options), scroll to Stored, then
press (Select).
• Press or to scroll to the message that you want
to use.
NOTE: If you want to view the message,
press (Details), then
press (Close).
•PressOK to select the message.
• Edit the message, if required.
•Press (Options), scroll to Save, then
press (Select).
1 Continue from Completing the contact on page 22.
To Next Page
Loading...
Need help?
General
