To Next Page

To Previous Page

5.9.2. The batteries can also be charged using the Quad-Bay battery charger (CRA-

A274). Connect the Quad-Bay charger to the power supply provided for the charger and

plug the power supply to an AC power source. Insert batteries into the charger (Figure

12). The batteries will start charging as the Power Gauge LEDs start flashing 4 second on

and 1 second off. The LEDs will stay solid on when a battery is fully charged. The

battery will be fully charged in approximately 4 hrs when using the quad-bay battery

charger.

Figure 12 Charging B27 Batteries in a Quad-Bay Charger

Please note: the temperature range to charge the battery is 0°C – 40°C (32°F – 104°F).

Although the reader will operate beyond this range, the battery may not charge

properly. To avoid temperature related battery issues, always charge the battery and

operate the reader between 0°C – 40°C (32°F – 104°F).

Please note: It is normal that the area around the serial label on the reader becomes

warm during charging.

For long-term storage or shipping, please remove the battery from the reader or the

quad-bay charger.

Code CR2700 User Manual

Other manuals for Code CR2700