5-4 Printing from DICOM Applications
Your key operator or DICOM application vendor must configure the
DICOM application running on each imaging device or image
viewing workstation to support printing to the Horizon imager.
To properly configure a DICOM application to support printing to
the Horizon imager, you need to know the Called AE Titles that can
be used to identify the imager, and its TCP port number.
The port number is
104
. The Called AE Titles are listed in the
following table, which also describes how they are used.
For more information about the Horizon information needed to
perform this configuration, refer to the
Horizon Imager Technical
Manual
.
`çåÑáÖìêáåÖ=íÜÉ=af`lj =^ééäáÅ~íáçå
&DOOHG$(7LWOH7KDW&DQ%H8VHG 'HVFULSWLRQ
3ULQWB6&3 )RUVWDQGDUGSULQWMREV
6SHFLDO%UDFNHW )RUSULQWLQJEUDFNHWLQJVKHHWV)RUPRUH
LQIRUPDWLRQUHIHUWR&KDSWHU
6SHFLDO6OLGH )RUSULQWLQJPPVOLGHV)RUPRUH
LQIRUPDWLRQUHIHUWRWKH+RUL]RQ,PDJHU
7HFKQLFDO0DQXDO
7KHQDPHRID-RE6HWWLQJVILOH )RUSULQWLQJXVLQJ-RE6HWWLQJVILOHVWR
VSHFLI\SULQWMRESDUDPHWHUV
To Next Page
