Codonics Horizon Series - Rebooting the Imager

Horizon Imager User’s Manual 3-9
%DVLF,PDJHU2SHUDWLRQV
oÉÄççí áåÖ=íÜÉ=fã~ÖÉê
Rather than powering the imager off, you may want to reboot the
imager. For example, if you suspect that an imager problem is
software-related, you could try rebooting to clear the problem.
1. Press the (power) key at the control panel.
The Power menu displays.
127(  7RFDQFHOWKHUHERRWDWWKLVSRLQWSUHVVWKH  NH\RUWKH NH\
2. Use the key to move the selector arrow to the 5HERRW option.
3. With the 5HERRW option selected, press the key.
Shutdown messages are displayed. When the shutdown
operation is complete, the imager reboots. The reboot process
takes approximately four to five minutes.
3RZHU
 3RZHU2II
5HERRW
8
7RUHERRWWKH
LPDJH
U
3
&$1&(/

(17(5