Codonics Horizon Series - Cleaning the Platen

Horizon Imager User’s Manual 2-11
6HWWLQJ8SWKH,PDJHU
2. Press the (power) key at the control panel.
127( $OZD\VXVHWKH NH\DWWKHFRQWUROSDQHOWRSRZHURQRIIWKHLPDJHU7KHSRZHU
URFNHUVZLWFKDWWKHEDFNRIWKHLPDJHUVKRXOGDOZD\VEHLQWKH  RQSRVLWLRQXQOHVVWKH
LPDJHULVEHLQJVHUYLFHGRUPRYHG
The control panel display shows startup messages as the imager
initializes and warms up. When the Status screen displays
(shown below), the imager is ready to receive images.
`äÉ~åáåÖ=íÜÉ=mä~íÉå
After powering on the imager for the first time, you should clean
the platen. For instructions on how to clean the platen, refer to
“Cleaning the Platen and Donor Guide Bar” on page 10-8.
6XSSO\
 1RFDVVHWWH
 1RFDVVHWWH
 1RFDVVHWWH
6WDWXV 2.
 1RVKHHWVTXHXHG
3