Pairing Strategy (DMA-IBASE-BT-XX)
In order to pair the base station and the reader in a single step without considering former pairing states and without
using the DataMan Setup Tool, scan the Pair code from the scan code sticker on the base station.
The reader then blinks green/blue until it gets paired with the base station (or until the end of the 20 second timeout
period). When the reader is put on the base station, the base station drops its pairing with its old reader and pairs with
the new reader.
Note: Scanning the Pair code puts the base station and the reader put on it into force pairing mode. This means
that the reader and the base it is put on get paired regardless of any assignments they both had previously. This
force pairing mode is valid for 20 seconds after reading the Pair code.
22
Connection Options
To Next Page
Loading...
