3. Select from the following authentication modes:
Authentication mode Encryption mode Requirements
Open System WEP-40, WEP-104 passphrase
WPA-PSK, WPA2-PSK TKIP, AES, TKIP/AES passphrase
EAP-TLS (see the section below) TKIP, AES, TKIP/AES l Client’s certificate
l CA’s certificate
l Client’s private key
l Client’s username
PEAP-MSCHAPV2 (see the section
below)
TKIP, AES, TKIP/AES l CA’s certificate
l Client’s username
l Client’s password
EAP-TLS Authentication Mode
Encryption methods: TKIP, AES, TKIP/AES are supported. All of these methods require specifying several PEM files,
which are created by the user’s local system administrator and contain certificate information.
These certificates are used to encrypt the communication between the Wi-Fi Access Point and the reader.
The following certificates are required:
l Client’s certificate. This must be different for each reader. It may be publicly accessible (for example, on a
company webpage).
l CA’s certificate (CA = Certificate Authority). One such file is created for each authentication server within the
company. It can be publicly accessible.
l Client’s private key. This must be different for each reader. It must not be publicly accessible, and must be stored
and handled confidentially.
Uploading a Certificate File to DataMan
You can upload these files in the DataMan Setup Tool one by one: click the folder button beside the fields and select the
appropriate file to upload it to the device.
A short message shows if a certificate is specified. The text “<not set>” appears in the field if there is no key or certificate
specified.
9
Networking
To Next Page
Loading...
