Chapter 4 Setting Delay Values
© 2010 Colby Instruments. PDL-100A Operating and Programming Manual Page 27
Note: When communicating to the PDL-100A with HyperTerminal and Winsock
protocol, command prompts are not displayed.
Now that HyperTerminal has started and is configured correctly, you can
enter commands and query the PDL-100A unit from this application. See
Chapter 5.0 Common Commands and System Commands for specific
commands supported.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...