Colby Instruments PDL-100A - CAL Calibration COMMAND

Chapter 5 Common Commands
© 2010 Colby Instruments. PDL-100A Operating and Programming Manual Page 34
*CAL Calibration COMMAND
The *CAL command performs a calibration check on the
electromechanical trombone and resets the delay position to
0.00 ps.
Command
Syntax
*CAL
Example
*CAL
Returns
None
Programming
Example
HP : OUTPUT 705;"*CAL"<NL>
NI : CWGPIB.Write “*CAL”
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com