Colby Instruments PDL-100A

To Next Page

To Previous Page

4.4.0 The MT-100A Menu Keys – DIAG ........................................................... 19

4.4.1 About the DIAG Menu options ................................................................ 19

4.4.1.1 DIAG MENU – Relays ....................................................................... 20

4.4.1.2 DIAG MENU – Device Calibration ..................................................... 20

4.4.1.3 DIAG MENU – Resetting the PDL-100A ........................................... 20

4.5.0 Working Remotely Through the GPIB Interface ...................................... 21

4.5.1 Connecting remotely over GPIB (IEEE488.2) ......................................... 21

4.5.2 Setting the GPIB (IEEE488.2) Address .................................................. 21

4.5.3 Setting the delay using GPIB (IEEE488.2) Commands .......................... 23

4.5.4 Using National Instruments Measurement and Automation Explorer ..... 23

4.6.0 Communicating with the PDL-100A over Ethernet TCP/IP. .................... 25

4.6.1 Default Network Addresses................................................................. 25

4.6.1.1 Programming over the Ehternet TCP/IP ........................................... 25

4.6.2 Using HyperTerminal and Ethernet (TCP/IP) ...................................... 26

4.7.0 Setting the delay over RS-232 Serial Port and PC ................................. 28

4.7.1 Attaching the MT-100A Microterminal to the RS-232 port ................... 28

4.7.2 Attaching the PC to the RS-232 port ................................................... 28

4.7.2.1 Programming over the RS-232 connection ...................................... 29

4.7.2.2 Error Checking ................................................................................. 29

4.7.3 Using HyperTerminal and RS-232 connection .................................... 30

Chapter 5.0

Common Commands ....................................................................33

5.1.0 Summary of Common Commands .........................................33

*CAL Calibration COMMAND .............................................................. 34

*CAL? Calibration Query QUERY .......................................................... 35

*IDN? Identification QUERY ................................................................. 35

*RST Reset COMMAND ...................................................................... 36

*OPC Operation Complete COMMAND ............................................... 37

*OPC? Operation Complete COMMAND ............................................... 37

*TST? Test Operation Query QUERY ................................................... 38

*ESE Event Status Enable COMMAND ............................................... 39

*ESE? Event Status Enable Mask QUERY ............................................ 40

*ESR? Operation Complete QUERY...................................................... 40

*CLS Clear Status COMMAND ............................................................ 41

Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Colby Instruments PDL-100A - Page 7