3.2 Entering data with the keyboard
The numerical keys of the keyboard (10) are used to enter data. If the value to be entered is a deci-
mal, enter the decimal point with the key ' ' (11).
Confirm the input with the ENTER key (12) to validate it. If the data range is exceeded, this is indica-
ted for a short time and the original value does not change.
Warning Warning
Exceeding value Short falling value
Now entering can be continued. The next permissible value of the decimal place is calculated and
indicated.
The indicated data can also be increased or reduced step by step with the arrow keys up (13) and
down (14). The change of data with these keys has to be terminated by depressing the ESC key (9).
Then the last indicated data are taken. Here takes place a continuous control of the data range, so
that unacceptable data can be avoided.
The ESC key (9) allows to abandon entering data by keyboard. Then the original value, valid before
the change will be indicated.
The ESC key (9) is used to jump back to the previous branch after having entered a value.
Note:
All minimum and maximum values of the functions are shown in the value ta-
bles of the Technical Appendix.
5999.530-01E 14.01.2004 CSWM 4 11
To Next Page
Loading...
