5.4 Label suppression (suppression of label scanner)
This function is used to enter the length forcing the label scanner to suppress the signals from the
backing paper web and the label after having detected the leading edge of the label. Entering can be
aborted by the ESC key. This function is used above all when relatively transparent labels are used,
for which the optical label scanner is disturbed by the print on the labels. This function also allows to
suppress the rebounding signals of mechanical label scanners.
SUPPRESSION OF THE
LABEL SCANNER
Length : 10 mm
5.5 Predispensing
The Predispensing function is used to adjust the predispensing length of the label. This length speci-
fies the distance by which the leading edge of the label is pulled forward after scanning.
PREDISPENSING
Value : 25.4 mm
Attention:
If a predispensing length exceeding the label length is entered, a malfunction of
the labeller may occur because the label gap is scanned at the wrong time. See
diagram 'Predispensing' in the Technical Appendix.
programmer
STOP
User level:
Operating mode:
programmer/operator
RUN/STOP
User level:
Operating mode:
Dispensing edge
Label
Labelscanner
Paperweb
Predispensing
5999.530-01E 14.01.2004 CSWM 4 21
To Next Page
Loading...
