7.3.2 Test EEPROM
The Test EEPROM function is used to test the EEPROMs of the monitor. A detected EEPROM er-
ror is indicated as follows.
TEST EEPROM
Test ok
7.3.3 Test keyboard
The Test keyboard function is used to test the keyboard of the monitor. All keys have to be depres-
sed once for the test. The sequence for the test is indicated. Keys F1...F5 are the function keys.
TEST KEYBOARD TEST KEYBOARD
F1 F2 F3 F4 F5 1 2 3 4 5 6 7 8 9 0
ESC . ENTER
Press all Keys Press all Keys
7.3.4 Test LED
The Test LED function is used to test the LED on the front panel. After selection of this function, all
LEDs flash, until the function is aborted with the ESC key.
TEST LED
Test in progress
Quit with [ESC]
7.3.5 Test LCD
The Test LCD function is intended to test the LCD of the control panel. After selection of this functi-
on, all elements of the LCD flash, until the function is aborted with the ESC key.
TEST LCD
Quit with [ESC]
5999.530-01E 14.01.2004 CSWM 4 39
To Next Page
Loading...
