8.5.1 Operating warnings
Entering an exceeding or short falling value by keyboard the following warning message is displayed:
Warning Warning
Excceding value Short falling value
If a function or a value is selected by the operator without having the permission for access the follo-
wing warning message is displayed:
Warning
Illegal access !
8.6 Nonstop - configuration and setup
Collamat Mode Item
Master + Slave Configuration Select language
Master + Slave Configuration Select user level
Master + Slave Configuration Set adapter magnet on/off
Master + Slave Configuration Set motor direction
Master + Slave Configuration Set polarity IFEED
Master Configuration Adjust error handling
Slave Configuration Adjust error handling
Master Configuration Set Nonstop mode to Master
Slave Configuration Set Nonstop mode to Slave
Master + Slave Programming Label length adjustment
Master + Slave Programming Label scanner sensitivity adjustment
Master + Slave Programming Predispensing adjustment
Master + Slave Programming Position adjustment
Master + Slave Programming Speed adjustment
Master + Slave Programming Max. speed adjustment
Master + Slave Programming Good suppression adjustment
Master + Slave Programming Labeling mode adjustment
Master + Slave Programming Profiling off
Master + Slave Programming Store program
5999.530-01E 14.01.2004 CSWM 4 49
To Next Page
Loading...
