You will need the following for each mass scale:
1 x 9-pin D-Sub male-female serial extension cable 0.5m in length
1 x coaxial DC plug-plug cable 0.4m in length
The following photo shows the relative position of the mass scales (two are on the left) and the CLAMS
interface board (one on the rights) that will connect from underneath the CLAMS shelf. The connecting cables
must pass through a structural support with obround cutouts (Left of center).
• Using a serial extension cable, connect the labeled “RS-232” port “Scale Address #???” of CLAMS
interface board to the “RS232” port of the mass scale. Be sure to pass the cable through the obround
cutout as shown.
To Next Page
Loading...