INTERVAL MACHINE COMPONENTS PROCEDURE
DAILY
BEFORE A LONG PERIOD OF INACTIVITY
Squeegee
Clean the vacuum chamber; the squeegee rubber blades; the vacuum nozzle (see
“CLEANING THE SQUEEGEE BODY”).
Debris hopper
Empty the debris hopper and clean inside (see “CLEANING THE DEBRIS HOPPER
(SWEEPING VERSION)”).
Brush head brushes
Clean the brushes on the brush head body (see “CLEANING THE BRUSH HEAD
BODY BRUSHES (SCRUBBING VERSION)”).
Clean the brushes on the brush head body (see “CLEANING THE BRUSH HEAD
BODY BRUSHES (SWEEPING VERSION)”).
Recovery tank
At the end of every working day, empty the recovery tank (see “EMPTYING THE
RECOVERY TANK”).
At the end of every working day, after having emptied the recovery tank, clean the
vacuum system lters (see “CLEANING THE RECOVERY TANK FILTERS”).
At the end of every working day, after having emptied the recovery tank, clean the
vacuum tube (see “CLEANING THE VACUUM TUBE”).
Solution tank
At the end of every working day, empty the solution tank (see “EMPTYING THE
SOLUTION TANK”).
WEEKLY
Machine water system
Clean the lter in the machine's water system (see “CLEANING THE WATER
SYSTEM FILTER”).
Clean the detergent tank located inside machine, valid for versions with CDS (see
“CLEANING THE DETERGENT TANK (CDS VERSIONS)”).
Squeegee rubber blades
Check that the rubber blades on the squeegee body are intact and inspect for wear;
if necessary, replace these (see “REPLACING THE SQUEEGEE BODY RUBBER
BLADES”).
Brush head brushes
Check that the brushes on the brush head body are intact and inspect for wear; if
necessary, replace these (see “REPLACING THE BRUSH HEAD BODY BRUSHES
(SCRUBBING VERSION)”.
Check that the brushes on the brush head body are intact and inspect for wear; if
necessary, replace these (see “REPLACING THE BRUSH HEAD BODY BRUSHES
(SWEEPING VERSION)”.
MONTHLY Squeegee rubber blade levelling
Check that the rubber blades on the squeegee body are level and if necessary,
adjust these (see “ADJUSTING THE SQUEEGEE BODY RUBBER BLADES”).
28
To Next Page
Loading...
